I need a sprocket ratio of 7:1
(that means 7 turns from the Motor Axle end on 1 turn on the Wheel axle)
BUT.... here comes the hard part:
I need to do this in 2 steps (read: 4 sprockets).
Here is how its constructed:
Axle 1 = Motor Axle
Axle 2 = Sprocket Axle
Axle 3 = Wheel Axle
All sprockets have to be ATLEAST 3cm diameter.
Sprocket on Axle 3 CAN be 14cm Diameter (wich means it doesnt HAVE to be this size).
All others MUST be smaller then 12,5cm accross.
Anyone can solve this?
This is also a way to get to panda island, so all of you get your brains crackling, so you can enjoy the sexy panda strippers we have waiting for you. :p
Mind you, its not as easy as 1:4:3
Theres some complex math involved
Last edited by Freakazoid on 06-25-2002 04:41 PM; edited 1 time in total _________________ Team -=[R.A.W.]=-
Roboteers at work.
"Being strong is like being a lady.. If you have to tell you are, you arent."
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You can vote in polls in this forum
